I was wondering if you fine folks would try to answer a question for me?
I use a Suzuki G13a engine with a Sj 410 4 speed gear box in a Sporting Trials car ( We try to go as far as we can up a hill before getting stuck using 2 wheel drive and road tyres!!! ).
I have a G16 which i am re-building the block to which I will fit my 1300 head ( as we run on gas so I will just swap it over ).
Is the Sj410 and the Sj 413 gearboxes the same length (bell housing to output flange )???
I am aware of the other differences 4/5 speed, longer input shaft and gear selector 1" further back.
All of which I can cope with, but a overall large difference in length would cause me problems in getting it into my car ( prop-shaft length etc).
Any help on this would be greatly appreciated.